Searching...
1.04.2015

How to Make DIY eCymbal Pads from Plastic Plate for Electronic Drums


CHOOSE YOUR PLASTIC PLATE.


USE SANDPAPER OR ANYTHING TO FLATING THE EMBOSS.

  


DRILL  HOLE FOR CYMBAL HOLDER/ STAND.


IF YOU USE CYMBALS ANTI-SPIN (ROTATION STOPPER), THEN MAKE THE SECOND HOLE FOR THE ANTI-SPIN.




USE ANY KIND OF RUBBER SUCH AS MAT, CAR FOOD PAD, MOUSE PAD, VARNISHED, ETC.




USE GLUE TO STICK THE MAT LAYERING THE PLATE.


 




COLORING TO MAKE IT NICE.




CHOOSE YOUR PIEZO SIZE.


SOLDERING AND CONECT IT TO THE FEMALE JACK.



OR DIRECTLY TO MALE JACK.



STICK THE PIEZO TO A RASHER MAT.




THEN STICK THEM TO THE PLATE.



THE PLATE SIZE IS SUITABLE FOR SPLASH CYMBALS.



APOLOGIZE FOR BAD TUTORIAL, BAD ENGLISH, AND ANYTHING.
THANKS YOU SO MUCH.


4 comments:

  1. and arduino code is?

    ReplyDelete
  2. WHICH GLUE DO YOU USE?? THIS IS A VERY IMPORTANT PART

    ReplyDelete
  3. You produced some decent points there. I looked on-line for the issue and located most individuals may go coupled with with all your site. plastic molding

    ReplyDelete

 
Back to top!